Table of Contents
Advertisement
8 electrolux
Operation
Hob Burners
To light a burner:
turn the relevant knob anticlockwise to
maximum position and push down the knob to
ignite.
After lighting the flame, keep the knob pushed
down for about 5 seconds. This will allow the
"thermocouple" (Fig. 2 - lett. D) to be heated
and the safety device to be switched off,
otherwise the gas supply would be interrupted.
Then, check the flame is regular and adjust it
as required.
If you cannot light the flame even after several
attempts, check the "cap" (Fig. 1 - lett. A) and
"crown" (Fig. 1 - lett. B) are in the correct position.
To put the flame out, turn the knob to the symbol
.
In the absence of electricity, ignition can
occur without the electrical device; in this case approach the burner with a
flame, push the relevant knob down and turn it anti-clockwise until it reaches
the"maximum" position.
When switching on the mains, after installation or a power cut, it is quite normal
for the spark generator to be activated automatically
Do not keep the control knob pressed for more than 15 seconds.
If the burner does not light even after 15 seconds, release the control knob, turn
it the "off" position and wait for at least one minute before trying to light the burner
again.
If the burner accidentally goes out, turn the control knob to the "off" position and
wait for at least 1 minute before trying to light the burner again.
A - Burner cap
B - Burner crown
C - Ignition electrode
D - Thermocouple
Fig. 1
Advertisement
Table of Contents
