Table of Contents
Advertisement
How to use the blade scraper:
1 Pull back the guard so that the
blade is visible.
2 Make sure that the blade is
clean and whole, otherwise it
could damage the plate. You
can buy new blades at a
hardware store.
3 Hold the scraper at an angle of
about 45° and scrape clean.
4 Carefully wipe off any dirt from
the blade with kitchen tissue.
5 After use, press the guard
forward so that it covers the
blade. Store the scraper out of
the reach of children.
Replacing the blade:
1 Open the scraper by fully
loosening the screw (no
screwdriver needed) and fitting
the new blade at the front edge.
2 Assemble the scraper and
tighten
the screw again.
3 Press the guard as far forward
as it will go to protect the blade.
Cleaning the oven
In order to facilitate cleaning, the step
units or baking plate rails should be
removed, see page 47.
Removing the baking plate rails
The baking plate rails are removed in
the same way as the step unit, see
page 47.
T
HE CATALYSIS ENAMEL
walls and top is porous and has a
certain self-cleaning effect. The oven
bottom, on the other hand is made of
a
and rather harder
SMOOTH
from which you can scrape off spilled
material with a spatula or something
similar.
on the oven
ENAMEL
Catalysis enamel
The oven gets hot during use.
Keep an eye on children.
Dirt on the enamel is partly burnt off
when the oven is used. If there are
flecks on the enamel, burn off the
oven at the highest temperature with
top/bottom heating for
30–60 minutes. Remove stubborn
flecks, for example fat, like this:
1 "Drench" the catalysis enamel
with soft soap and hot water.
Use a nylon brush on the
flecks. Leave it alone for one
hour.
2 Then turn on
bottom heating and the highest
temperature.
3 Switch off the oven after three
hours.
Never use oven cleaning compound
or sharp objects on the catalysis
enamel.
The smooth enamel
The following should be done if the
oven bottom is very dirty:
1 Spill or boil-over that has
become stuck can be loosened
with a spatula or something
similar.
2 Spread soft soap on the bottom
of the oven with a sponge.
3 Close the door. Set the oven at
100°C with
heating for about 10 minutes.
4 When the oven has cooled
down, rinse it with clean water
or, if necessary, rub carefully
with a soap pad. Wipe dry.
43
top and
top and bottom
Advertisement
Table of Contents
