Electrical Connection - Electrolux EHGL3 User Manual

28 www.electrolux.com

12.2 Electrical connection

Use a power cable of H05VV-F or higher.
Connect the appliance to a socket supply
line. If there is no socket supply line, the
electrical installation must have an isola-
tion device which lets you disconnect the
appliance from the power supply. The iso-
D
F
12.3 Connection diagram 400 V
min. 20
A B
20
5. Use at least 2 screws to fix the oven
on both sides (Detail A).
WARNING!
When installing next to a wood-fu-
elled boiler, a heatproof and heat-
insulating plate must be mounted
10
at the height of the appliance and
at least 30 cm deep.
A
lation device must have a contact opening
width of minimum 3 mm (in reference to
NIN SEV 1000). The customer must have
a socket for the electrical connection that
is accessible and outside the coordination
room. The length of the connection cable
must be approximately 120 cm with lines
connected directly to the power supply.
Only a qualified person can con-
nect the appliance to the electrici-
ty supply.
1. Open the mains terminal cover (D).
2. Put the connection cable into the
E
supplied rings (E). This is to prevent
the cable from rubbing against the
drawer. The connection cable is on
the housing side.
3. Install the cable grip (F).
4. Connect the terminal as in the illustra-
tion.
5.
Put the cable into the strain relief
clamp.
6. Close the mains terminal cover.
Phase definitions: L1, L2, L3 (or R, S,T)
WARNING!
If service is required always dis-
connect the appliance from the
power supply.