How To Finish Unpacking - AEG Electrolux D1100-4 User Manual

How to finish unpacking

• Place packed appliance next to the
space in which it will be installed.
• Remove the appliance packing except
for bottom tray, which should be left in
position until the appliance is ready to be
fitted into its cabinet.
• NOTE:
It is imperative that the
appliance is left in the base to protect
both the appliance and the floor.
• Ensure the user is given these operating
instructions.
Important:
mains, miniature circuit breaker
and if appropriate, remove fuse
before commencing any electrical
work.
To remove cover of mains
terminal
From the rear of the appliance, remove
mains input terminal cover to gain access to
terminal block.
•
First remove retaining screw with
pozidrive screwdriver. See Fig. 4.
•
Prise cover loose using screwdriver in
position (1) then lever off with
screwdriver in position (2) at either side.
See Fig. 5.
•
Lift cover and remove screw from cable
clamp. See Fig. 6.
40
Switch off at the
Fig. 4
Fig.5
Fig.6