Fan Leds - Qlogic SilverStorm 9000 Hardware Installation Manual

2 – Installation
Installation Tasks
Any leaf module Attention LED is on, or it has been determined that a leaf is not
❥
functioning (even if it is unable to light the LED).
The chassis status LED is
and indicates one of the following conditions:
The system ambient temperature exceeded 60 degrees C.
❥
No functional fan trays are present.
❥
No functional spines are present.
❥
No functional leaves are present.
❥
The chassis status LED is off when:
There are no functional power supplies present.
❥
There are no management cards in the system
❥
AC power has been removed from the system.
❥
2.3.7.6.2
Subnet Manager Agent (SMA) LED
There is a single SMA LED associated with each hemisphere of the system. This
LED is
Subnet Manager is running anywhere else in the fabric.
2.3.7.6.3
RJ45 LEDs
The RJ45 connectors have two LEDs, Act and 100. The 100 LED is
a 100Mbps link is connected. The Act LED is
been established, and blinking when the link is active.
2.3.7.6.4

Fan LEDs

Fan LEDs indicate the following status(es):
Green
❥
Amber
❥
A single fan failure when the rotation speed is less than 4000 RPM or greater
❥
than 10950 RPM.
Red
❥
The fan tray is not responding to commands for configuration and
❥
temperature-related operations.
A fan is not responding to commands for temperature and speed related
❥
operations.
2-22
Red
Blue if Fabric Manager license is installed and enabled on this switch or if
indicates that the fan is functioning properly.
indicates that the following warning condition exists:
indicates a possible problem, including:
when the system can no longer function properly
Green
Q
Green
when an Ethernet link has
D000024-000 Rev. A
when