Qlogic SilverStorm 9000 Hardware Installation Manual page 35

Q
That the Ethernet port has successfully established a link. The LED is off when
■
a link is down.
2.3.7.13
Activity (TX/RX)
The Activity LED is a Green LED indicating:
There is link activity on an Ethernet port. The LED is off when there is no link
■
activity.
2.3.7.13.1
Spine/Management Module Management LEDs
Each spine module has three management LEDs:
Capable:
❥
Green
❥
❥
Stat:
❥
Green
❥
❥
Act:
❥
Green
❥
redundantly-managed system, this would indicate the master spine.
Off indicates that the management board is in the standby mode (if the STAT
❥
LED is Green). In a redundantly-managed system, if the Capable LED is also
Green, this would indicate the slave spine.
DDR (Spine Module Only):
❥
Green
❥
Off indicates that the switch is not capable of running at DDR speeds (i.e.,
❥
SDR only).
2.3.7.13.2
Activating/Deactivating the Embedded Fabric Manager
If the embedded (FM) has been purchased, it requires a license key to activate it
via Chassis Viewer. The license key information is contained in an envelope marked
"Fabric Manager License". This envelope is packed in the box with the switch. For
detailed information on adding a license key, refer to the section "License Keys;
Key Administration" in the SilverStorm 9000 Users Guide. For information on
activating the Fabric Manager, refer to the section "QuickSilver Fabric Manager
Control" in the SilverStorm 9000 Users Guide.
D000024-000 Rev. A
indicates that the spine slot supports management.
Off indicates that the spine slot does not support management.
indicates that a management board is present.
Off indicates that no management board is present.
indicates that management board is in the active mode. In a
indicates that the switch is capable of running at DDR speeds.
2 – Installation
2-25