Qlogic SilverStorm 9000 Hardware Installation Manual page 34

2 – Installation
Installation Tasks
DC voltages on the board are slightly out of tolerance (12V Bulk, 5V, 3.3V,
❥
1.8V, VBIO are all monitored).
The module can no longer function properly. The system will take the
❥
appropriate actions to ensure that no damage is done to its components.
Blinking
❥
For each FVIC Fibre Channel port, the Activity (ACT) and Quality (QUAL) LEDs
indicate:
Activity (ACT) LEDs:
❑
Quality (QUAL) LEDs:
❑
❑
❑
❑
2.3.7.8
FVIC Fibre Channel Port LEDs (9020, 9040, 9080, 9120 and 9240)
2.3.7.9
Link/Activity
The green Link/Activity LED will blink indicating
Fibre Channel IO activity on the port. The LED is off when a link is down.
■
2.3.7.10
Fault
The Fault LED is a solid Amber LED indicating:
A fault condition related to the Fibre Channel connection for a specific port. The
■
Fault LED will be on if a problem is detected in either the Fibre Channel controller
or in the small form factor pluggable (SFP) optical transceiver for a specific port.
2.3.7.11
EVIC Ethernet Port LEDs (9020, 9040, 9080, 9120 and 9240)
2.3.7.12
Link
The Link LED is a solid Green LED indicating
2-24
Amber (once every four seconds) - LED test state.
Blinks ON for each transmit or receive on the port.
Constant - no errors.
Blink slowly - receiver bit errors are detected.
Blink fast - low signal-to-noise ratio (SNR) close to an error condition.
Off when an auto-negotiation is in progress or an error condition exists.
Q
D000024-000 Rev. A