Power Specifications; A.5 Power Specifications - Qlogic SilverStorm 9000 Hardware Installation Manual

Power Specifications

A.5
Power Specifications
All products within the 9000 MPFD series use a common switching power supply.
System power attributes are shown in the table below. Power supplies are hot
pluggable and N+1 redundant.
Model #
Maximum # of
Power
Supplies
Maximum
output per
supply
Input voltage
Input
frequency and
phase
Maximum
current per
supply
Power Factor
correction
Power Inlet
connector
# of Power
Inlets
Power Cord
connector
The 9120, 9080, 9040 and 9020 systems have two independent AC inputs and one
common DC output. Each AC input supplies power to half of the power supplies.
In a 9240 system there are two independent DC outputs, which are labeled as
hemispheres
supplies and the upper hemisphere is powered by the upper 6 supplies. There are
four independent AC inputs: two in each hemisphere. Each AC input within a
A-4
Table A-4. System Power Attributes
9240 9120
12 6
4 2
(see figure A-1). The lower hemisphere is powered by the lower 6
9080
6
350 Watts
90-264 VAC autoranging
50/60 Hz, 1 Phase
4 Amps
95%
IEC320-C14
2
IEC320-C13
Q
9040 9020
4 2
2 2
D000024-000 Rev. A