Adaptec ASR-6805Q User Manual page 38

a) Attach the full-height bracket to the mounting plate. The full-height bracket is installed on the
front side of the mounting plate (the side with the bents), with the mounting screws inserted
from the back, as shown below. Be sure to attach the mounting plate to the bracket with recessed
side at the bottom!
Recessed side
b) Thread the cable-ties through the slots on the supercapacitor module and affix to the mounting
plate, as shown in the next figure. The cable-ties should completely encircle the supercapacitor
module and mounting plate to ensure that it is held in place securely.
c) Set the mounting plate aside; continue with the steps below.
2. Turn off your computer and disconnect the power cord. Open the cabinet, following the
manufacturer's instructions.
3. Select an available PCIe expansion slot that's compatible with your RAID controller and remove the
slot cover, as shown in the figure below. (PCIe bus compatibility is marked on the controller figures
in About Your RAID Controller
backplane; you will use the empty slot to install the supercapacitor mounting plate, after you install
the controller. Remove the slot cover for the mounting plate, then continue with the next step.
Proprietary and Confidential to PMC-Sierra, Inc.
Document No.: CDP-00277-02-A Rev. A, Issue:
Serial Attached SCSI RAID Controllers Installation and User's Guide
on page 17.) Be sure to choose a slot next to an empty slot in the
38