Connecting External Devices - Adaptec ASR-6805Q User Manual

1. Install the SSDs in your server. For servers with a standard 2.5-inch drive tray, install the SSD directly
into the tray. If your server does not have a standard 2.5-inch drive tray, use a bracket or adapter
which enables it to fit properly.
Typical SSD installation
2. Use an internal mini-SAS or mini-SAS HD to SATA cable, as required, to attach the SSD(s) to the
controller, as shown in the example below.
Internal x4 mini-SAS HD connector
3. When all SSDs have been installed and connected, close your computer cabinet, reattach the power
cord, then continue with

Connecting External Devices

Note: If you are not connecting any external devices, see the following section,
Steps on page 43.
Proprietary and Confidential to PMC-Sierra, Inc.
Document No.: CDP-00277-02-A Rev. A, Issue:
Serial Attached SCSI RAID Controllers Installation and User's Guide
To other SSDs
SSD connected to controller with
internal mini-SAS HD to SATA Fanout cable
Connecting External Devices
Use a 2.5" to 3.5" adapter to
install your SSD if server does
not have 2.5" tray.
Single-port connector
on page 42.
Next
42