Setting Originals - Lanier 3730 Operating Instructions Manual

Setting Originals

You can set your originals in the Doc-
ument Feeder.
❖ How to set A4, B5 JIS (Japanese
Industrial Standard), A5, 5
1 1
8 / "×11, 8 / "x14" and 8"x13" size
2 2
originals
❖ How to set A5 and 8
originals
1 1
/ "×8 / ",
2 2
1 1
/ "× 5 / "size
2 2
Note
❒ When sending a fax, the image
output at the other end depends on
the size and direction of paper
used in the receiver's terminal. If
the receiver does not use paper of
the same size and direction as that
of the original, the fax image size
m a y b e r e d u c e d o n o u t p u t ,
trimmed at the both edges, or di-
vided into two or more sheets.
When sending an important origi-
nal, we recommend that you ask
the receiver about the size and di-
rection of the paper used in their
terminal.
❒ Make sure that all ink, correcting
fluid, etc., has completely dried be-
fore setting your original. If it is
still wet, the scanner will be
marked and those marks will ap-
pear on the received image.
❒ You can set the original any time
up until you press the {Start} key.
Setting Originals
2
25