Attach The Front Fender - Schwinn 26” User Manual

Attach the Front Fender

Parts: Front fender, main frame
Hardware: washer, long screw, small screw,
contoured washer
Tools: Phillips head screwdriver, adjustable pliers
See the facing page for diagrams of the following steps.
1 . Remove the fork protector (not shown).
2 . Disconnect the brake noodle from the brake
carrier by:
a . Using a 5 mm allen wrench loosen the
cable anchor bolt enough so the cable
can move freely.
b . Lift the brake noodle and cable out of the
brake carrier.
15
3 . Remove the hardware from the fork.
4 . Position the front fender so the attachment bar is
on the outside of the main frame.
5 . Place a washer on the screw and slide it through
the attachment bar, and the hole in the fork.
6 . Place the spacer on the end of the screw, making
sure the contour of the spacer fits the contour of
the fork.
7 . Place the washer and nut behind the spacer, and
loosely tighten.
8 . Align the fender braces with the small hole in the
fork and loosely screw the fender braces to the fork.