Hub Bearings - Schwinn 26” User Manual

Drivetrain maintenance continued . . .
Inspect
Crank Set Every month, check the crank set (crank
arms, chain rings, and bottom bracket axle
and bearings) is correctly adjusted and tight.
Remove the primary chain

Hub Bearings

Hub bearings require special thin wrenches called
"cone wrenches". If you do not own these tools, do
not attempt hub bearing adjustments. Have a qualified
bicycle mechanic perform the adjustment if you have
any doubts.
1 . Check to make sure neither locknut is loose.
2 . To adjust, remove wheel from bicycle and loosen
the locknut on one side of the hub while holding the
bearing cone on the same side with a cone wrench.
3 . Rotate the adjusting cone as needed to eliminate
free play.
Action
4 . Re-tighten the locknut while holding the adjusting
cone in position.
5 . Re-check that the wheel can turn freely without
excessive side play.
Maintenance
Replace cable.
44