HR7012 ReaR Seat Video HeadReSt SyStem
Remote ContRol and HeadPHone batteRy inStallation
installation of the Remote Control battery
The remote control comes with a battery already installed with a Pull Tab to prevent battery
discharge� Remove the Pull Tab before attempting to use the remote� (Figure 7)�
Note: The remote control will only operate this device. It is not a universal remote control and
will not control other equipment.
Remote control
Back View
1� W hile holding the remote control, insert thumbnail into the battery door side notch (1) and
index fingernail into battery door upper notch (2) and slide battery holder open (Figure 8)�
2� Install one CR2025 battery (1) (Figure 9)�
Note: Make sure that the proper polarity (+ or -) is observed.
3� Slide the battery holder back into the remote control until it locks (Figure 10)�
(1)
(2)
figure 8
Protective Pull tab (Clear Plastic )
figure 7
(1)
owner's manual
CR2025
3V
figure 9
9