Table of Contents
Advertisement
Configuration
(Standalone)
Sound-Active
Mode
Automatic Mode
Auto Program
Speed
Footswitch
Operation
Page 12 of 16
Set the product in one of the standalone modes to control without a DMX controller.
· Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode (Static,
Automatic, or Sound-Active) to a DMX string connected to a DMX controller.
Products in standalone mode may transmit DMX signals that could interfere with
the DMX signals from the controller.
To enable the Sound-Active mode, do the following:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Press <ENTER>.
3.
Turn the music on and adjust the sound sensitivity knob until the product starts
responding to the beat of the music.
4.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To enable the Automatic mode, follow the instructions below:
1.
Press <MENU> repeatedly until AUTO shows on the display.
2.
Press <ENTER>.
To set the auto program speed, do the following:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Press <ENTER> and S 1—S100 (slow to fast) shows on the display.
3.
Use <UP> or <DOWN> to select the desired auto program speed.
4.
Press <ENTER>.
The included footswitch provides quick access to preset colors, color-change programs, and
sound-activation through the COREbar™ 4 microphone.
To use the footswitch:
1.
Power the product on.
2.
Connect the footswitch to the COREbar™ 4 with the 4-pin connection cable with plug.
3.
Press pedal #1 (Presets) to activate control. When working, all the LEDs will light white,
which is the first function of pedal #1.
4.
Use the chart below to activate the desired function.
To disconnect the footswitch:
1.
Unplug the footswitch from the COREbar™ 4.
2.
Unplug the power cable from the COREbar™ 4.
3.
Power the COREbar™ 4 again to operate without the footswitch.
Pedal
Sub-option
1 x press
2 x press
3 x press
4 x press
1 - Presets
5 x press
6 x press
7 x press
8 x press
9 x press
2 - Sound
N/A
3 - Blackout
N/A
The COREbar™ 4 footswitch will work properly in any mode. No settings are
needed to be modified before using the footswitch.
Function
White
Red
Green
Blue
Yellow
Magenta
Cyan
Color change every second in a continuous loop
Color change every 3 seconds in a continuous loop
Sound-activated
Immediately turns off all the LEDs
COREbar™ 4 User Manual
Advertisement
Table of Contents
