Table of Contents
Advertisement
Configuration
(DMX)
Starting Address
DMX Channel Assignments and Values
Channel
3-CH
Mega Trix™ User Manual Rev. 4
Set the product in DMX mode to control with a DMX controller.
1.
Connect the product to a suitable power outlet.
2.
Turn the product on.
3.
Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Mega Trix™ uses up to 3 DMX channels in its 3-channel DMX mode, which defines
the highest configurable address to 510.
If you are not familiar with the DMX protocol, you may refer to the DMX Primer section in
the
Technical Information
section.
To select the starting address, do the following:
1.
Press <MODE> repeatedly until d 1 shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select the starting address.
4.
Press <ENTER>.
Function
1
Auto Programs
2
Program Speed
3
Strobe
Value
Setting
000 ó 249 Select auto program (1-50)
250 ó 255 Sound Active Mode
000 ó 255 0-100% (slow to fast)
000 ó 255 0-100% (slow to fast)
Page 11 of 21
Advertisement
Table of Contents
