Remote Control - Dimplex DFB8842 Owner's Manual

Operation
switch is in the Flame and
Flame & Heat positions, the
fireplace unit will not operate
with the remote control.
!
NOTE: The heater on your
fireplace may emit a slight,
harmless odor when first used.
This odor is a normal condition
caused by the initial heating of
internal heater parts and will
not occur again.
Resetting The Temperature
Cutoff Switch
The heater is protected with a
safety device to prevent overheat-
ing. Should the heater overheat,
an automatic cut out will turn the
heater off and it will not come
back on without being reset. It
can be reset by switching the ON/
OFF Switch to OFF and waiting
five (5) minutes before switching
the unit back on.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call Dim-
plex North America Limited
at 1-888-346-7539. Have
the product Model and Serial
Numbers ready when calling.
10

Remote Control

The remote control has a range of
approximately 50 ft (15.25 m). It
does not have to be pointed at the
fireplace and can pass through
most obstacles (including walls).
It is supplied with 243 indepen-
dent frequencies to prevent inter-
ference with other units.
Battery Installation (Figure 4)
Figure 4
Batteries
Child Lock
into the remote control (includ-
ed).
3. Ensure child lock is in the
position.
4. Replace the battery cover.
!
NOTE: When the "BAT"
symbol is present on the remote
control it is recommended to
1. Depress
the tab on
the battery
cover on
the back of
the remote
control and
remove
battery
cover.
2. Install two
AAA bat-
teries
www.dimplex.com