Replacing The Headlight Bulb; Replacing The Tail/Brake Light Bulb - Yamaha AEROX YQ50 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR

Replacing the headlight bulb

If the headlight bulb burns out, replace
it as follows.
CAUTION:
It is advisable to have a Yamaha
dealer perform this job.
1. Remove cowling A. (See page
6-5.)
2. Disconnect the headlight coupler.
3. Remove the headlight bulb holder
by turning it counterclockwise, and
then remove the defective bulb.
6
1
ZAUM0283
1. Headlight bulb holder
EAUM2110
WARNING
Headlight bulbs get very hot. There-
fore, keep flammable products away
ECA10670
from a lit headlight bulb, and do not
touch the bulb until it has cooled
down.
4. Place a new headlight bulb into po-
sition, and then secure it with the
bulb holder.
5. Connect the coupler.
6. Install the cowling.
7. Have a Yamaha dealer adjust the
headlight beam if necessary.
EWA10790
Replacing the tail/brake light
bulb
1. Remove the tail/brake light lens by
ZAUM0284
2. Remove the defective bulb by
3. Insert a new bulb into the socket,
4. Install the lens by installing the
CAUTION:
Do not overtighten the screws, oth-
erwise the lens may break.
6-21
removing the screws.
pushing it in and turning it counter-
clockwise.
push it in, and then turn it clock-
wise until it stops.
screws.
EAU24131
ECA10680