Replacing The Fuse; Replacing A Headlight Bulb - Yamaha BWS CW50 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR

Replacing the fuse

1 1 2 2
ZAUM0570
1. Battery
2. Fuse
The fuse holder is located behind panel
B. (See page 6-5.)
6
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "
electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
Specified fuse:
7.5 A
EAU23500
CAUTION:
Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
3. Turn the key to "
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
" and turn off all
ECA10640

Replacing a headlight bulb

If a headlight bulb burns out, replace it
as follows.
1. Place the scooter on the center-
2. Remove cowling A. (See page
" and turn on
3. Unhook the headlight bulb holder,
ZAUM0571
1. Unhook the headlight bulb holder.
2. Take the headlight bulb holder off.
3. Headlight bulb holder
6-20
stand.
6-5.)
and then remove the defective
bulb.
1
EAUM1410
2
3