Setting The Print Area - Epson Disc Producer PP-100 User Manual

Setting the Print Area

Select from Standard and Wide, or set an arbitrary size (User Defined label size).
The print areas of Standard and Wide are shown in the table below. Printing will be done in the gray area in the figure
below.
Standard
Inside Diameter
Outside Diameter
Inside Diameter
45.0 mm
 Before printing, check that the set print area does not exceed the print area of the
discs you are using.
 Printing on the stack ring (concentric circular projection) portion may result in uneven
coloring.
 Printing on the stack ring (concentric circular projection) portion may result in ink
getting on the discs, peeling off, or discs sticking together after printing.
 See
"Printing on User Defined Label Size Discs" on page 74
the user defined label size.
 When printing with applications other than EPSON Total Disc Maker, use the following
Notes
settings to create print data.
 Paper size: 124 x 124 mm
 Margins on all sides: 2 mm
The setting procedure of the print area differs, depending on whether you publish with EPSON Total Disc Maker or
with the other applications.
When publishing with EPSON Total Disc Maker
Set in the dialogue that is displayed when you click
Disc Maker.
When publishing with the other applications
Set in Label size in the Print Settings area of the printer driver.
Outside Diameter
116.0 mm
[Set Inner/Outer Diameter] in Label view of EPSON Total
Wide
Inside Diameter
Outside Diameter
Inside Diameter Outside Diameter
25.5 mm
for the setting procedure of
Publishing Discs
116.0 mm
53