Hanging The Fan; Canopy Electrical Connections; Canopy Hatch Installation - Casablanca Metropolitan Owner's Manual

Step 3. To hang the fan body in the can-
opy, hold the fan body firmly and insert
the nylon ball into the canopy opening.
Check that no wires were pinched. Rotate
the fan body until the slot in the nylon
ball fits into the pin opposite the canopy
opening.
note: Fan weighs 25lbs.
Step 4. Attach the fan wires to the ceiling fixture outlet box
wiring by twisting the bare ends of the wires together and
then securing with a wire nut. Test that the connection is
secure by pulling on the wire nut. Connect in this order:
Electrical Connections
• GREEN leads from mounting plate and fan to GROUND
conductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to BLACK power wire in
ceiling outlet box. Secure with wire nut.
Step 5. Tuck the wires into the canopy
with the wire nuts pointed upwards, so
that the WHITE and BLACK wires are on
opposite sides of the canopy and all wires
are clear of the canopy opening.
Step 6. Install canopy hatch with the
last canopy screw and lock washer. To
do this, tilt the fan body away from the
hatch opening.
Tighten the screws firmly by hand only,
Step 7. Straighten the fan, then check
to ensure that there is no movement be-
tween the canopy and ceiling or Hang-Tru
ball and top support shaft.

HANgINg THE FAN

BALL

CANOPy ELECTRICAL CONNECTIONs

CANOPy HATCH INsTALLATION

note: Write down the
Serial Number and the
model number for future
reference.
M
etropolitan
SLOT
2 BLACK WIRES
2 WHITE WIRES
3 gREEN WIRES
WIRE NUT
CANOPy
HATCH
LOCK
WASHER
CANOPy
SCREW
®
PIN
TILT THE
FAN TO
INSTALL
LAST
CANOPy
SCREW
5