Table of Contents
Advertisement
Step 8a. To hang the fan body in the canopy, hold the fan
body firmly and insert the ball into the canopy opening.
Check that no wires are pinched. Rotate the fan body until
the slot in the ball fits into the pin opposite the canopy
opening.
Step 8b. Trim excess motor wires, leaving at least 6 inches
above the downrod. Strip
1
/
2
of each wire using a wire stripper (available at your local
hardware store).
CANOPY ELECTRICAL CONNECTIONS
Step 9. Attach the fan wires to the ceiling fixture outlet
box wiring by placing the bare ends of the wires side by
side and then securing with a wire nut. Test that the
connection is secure by pulling on the wire nut. Connect
in this order:
• GREEN leads from mounting plate and downrod
assembly of fan to GROUND conductor of power
source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in
ceiling fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to black POWER wire
in ceiling outlet box. Secure with wire nut
NOTE: If the color of your household's wires differ from
that described, consult an electrician.
Step 10a. Tuck the wires into the canopy with the wire
nuts pointed upwards, so that the WHITE and BLACK
wires are on opposite sides of the canopy and all wires are
clear of the canopy opening.
Step 10b. Install the canopy hatch with the last canopy
screw and lock washer using the provided screwdriver. To
do this, tilt the fan body away from the hatch opening.
Tighten the screws firmly.
Step 10c. Straighten the fan, then check to ensure that
there is no movement between the canopy and the ceiling
or the Perma•Lock
™
downrod and the ball assembly.
8
HANGING THE FAN
-inch insulation from the end
CANOPY HATCH INSTALLATION
Ball
Slot
Wire Nut
2 Black
Wires
2 White
Wires
3 Green
Wires
Pin
Advertisement
Table of Contents
