Da-Lite ViewShare Advantage Electrol Retrofit Instruction Book page 8

Installation of ViewShare Screen and Roller Assembly
NOTE: The ViewShare screen and roller assembly, which
includes brackets and arms, must be installed as a complete unit.
Do not attempt to disassemble these components during
installation.
1. Remove two 1/4 – 20 nuts from pin end and motor end mounting
brackets on the ViewShare screen and roller assembly shipping
board (Figure 15).
NOTE: If you transferred you existing motor, the motor end nuts
have already been removed.
2. Remove screws from both L-brackets that hold the slat in place
and carefully allow the slat to rest behind the ViewShare screen
and roller assembly (Figure 15).
NOTE: If you transferred your existing motor, the L-brackets have
already been removed.
3. Install ViewShare screen and roller assembly by placing the unit
inside of case and secure motor end bracket by aligning bracket
holes with bolts. Secure with two 1/4 – 20 nuts (Figure 16).
4. After the motor end is completed in Step 3, secure pin end by
aligning bracket holes with bolts. Secure with two 1/4 – 20 nuts
(Figure 16).
5. Once both ends are secured, ensure that the mounting brackets
are parallel with both ends of the case (Figure 16).
NOTE: Brackets must be parallel with the case to ensure proper
alignment of arms. Misalignment may cause damage to screen
surface and arm assemblies.
8
Shipping
L-Bracket
Motor End
1/4 – 20 Nuts
Bracket Parallel
to End
1/4 – 20 Nuts
Figure 15
Pin End
1/4 – 20 Nuts
Bracket Parallel
to End
Figure 16