Da-Lite ViewShare Advantage Electrol Retrofit Instruction Book page 7

Transfer of Existing Motor (continued)
8. Carefully lift the roller above the mounting bracket and remove the
wood block and plug from the end of the
roller (Figure 13).
9. Insert previously set aside motor into the ViewShare fabric
and roller assembly.
NOTE: When transferring the existing motor into the roller,
be careful to avoid unintentional damage to the screen and
arm assemblies.
10. Lower the roller, slide the bracket onto the motor end of roller
and insert retainer clip (Figure 14).
11. Align the motor end bracket using the mounting holes as
a guide and tighten the motor end arm bracket nut (Figure 12).
12. Re-attach the black L-bracket on the pin end of the roller (Figure 10).
Motor
Plug
Figure 13
Figure 14
Wood
Block
Retainer
Clip
7