Cisco TelePresence System Codec C90 Reference Manual page 130

Cisco TelePresence System Codec C90
Contents Introduction
xCommand SystemUnit Notifications RemoveAll
Clears the list of system notifications that are reported by xStatus SystemUnit Notifications Text/
Type.
Requires user role: ADMIN
Example:
xCommand SystemUnit Notifications RemoveAll
*r NotificationsRemoveAllResult (status=OK):
** end
xCommand SystemUnit ReleaseKey List
List all software versions that the system has a valid release key for.
Requires user role: ADMIN
Example:
xCommand SystemUnit ReleaseKey List
*r SystemUnit ReleaseKey 1 Version: "TC1"
*r SystemUnit ReleaseKey 2 Version: "TC2"
*r SystemUnit ReleaseKey 3 Version: "TC3"
*r SystemUnit ReleaseKey 4 Version: "TC4"
*r SystemUnit ReleaseKey 5 Version: "TC5"
** end
Codec C90 API Reference Guide TC7.0, JANUARY 2014.
D14641.15
About the API xConfiguration
TStringSend commands
xCommand TStringSend
130
xCommand xCommand
Send data to far end, e.g. for TelePresence control systems. Uses the H.245 control channel (TCP).
Works with H.323 calls only.
Message: Enter the message to be sent to the far end.
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run
the xStatus Call command to see the CallId.
Requires user role: USER
Parameters:
CallId(r): <0..65534>
Message(r): <S: 1, 1450>
Example:
xCommand TStringSend CallId:1 Message:"This is an example"
*r TStringSendResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.