Cisco TelePresence System Codec C90 Reference Manual page 123

Cisco TelePresence System Codec C90
Contents Introduction
Provisioning commands
xCommand Provisioning StartUpgrade
The codec software can be upgraded from the provisioning server. When starting the upgrade the
software is automatically downloaded and installed. The codec reboots to complete the software
upgrade.
Requires user role: ADMIN
Example:
xCommand Provisioning StartUpgrade
*r StartUpgradeResult (status=OK):
** end
xCommand Provisioning CompleteUpgrade
Starts installing the software upgrade if you wish to install it before it is set to do so.
Requires user role: USER
Example:
xCommand Provisioning CompleteUpgrade
*r CompleteUpgradeResult (status=OK):
** end
xCommand Provisioning PostponeUpgrade
Postpones the installing of the software upgrade.
Requires user role: USER
Parameters:
SecondsToPostpone(r): <0..65534>
Example:
xCommand Provisioning PostponeUpgrade SecondsToPostpone: 60
*r PostponeUpgradeResult (status=OK):
** end
Codec C90 API Reference Guide TC7.0, JANUARY 2014.
D14641.15
About the API xConfiguration
xCommand Provisioning CUCM CAPF OperationStart
xCommand Provisioning CUCM CTL Delete
123
xCommand xCommand
Starts a pending CAPF (Certificate Authority Proxy Function) operation toward the CUCM. When the
CUCM administrator initiates an operation that the endpoint should perform (like installing, updating
or deleting certificates), this command can be used to start the CAPF operation.
AuthString: Set the authentication string required for the CAPF operation.
Requires user role: USER
Parameters:
AuthString(o): <S: 4, 10>
Example:
xCommand Provisioning CUCM CAPF OperationStart AuthString: 123456
*r CAPFStartResult (status=OK):
** end
Delete the stored CTL and ITL files (CTL: Certificate Trust List, ITL: Identity Trust List).
Requires user role: USER
Example:
xCommand Provisioning CUCM CTL Delete
*r DeleteResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.