Cisco TelePresence System Codec C90 Reference Manual page 92

Cisco TelePresence System Codec C90
Contents Introduction
xCommand Audio LocalOutput Update
Update the settings of the local output given by the output ID.
OutputId: A unique identifier for the local output.
Name: Choose a name that describes the local output.
Loudspeaker: If one or more of the output connectors are connected to a loudspeaker, this signal
should be a reference signal to the echo canceler. Hence set loudspeaker to On. NOTE: When
microphone reinforcement is disabled there should only be one loudspeaker local output.
Channels: Set channels to 1 to mix the local and remote inputs into a mono signal. To mix the inputs
into a stereo signal, set channels to 2.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
Name(r): <S: 0, 255>
Loudspeaker(r): <On/Off>
Channels(r): <1..2>
Example:
xCommand Audio LocalOutput Update OutputId: 5 Name: "Loudspeaker"
Loudspeaker: On Channels: 2
OK
*r AudioOutputGroupUpdateResult (status=OK):
** end
xCommand Audio LocalOutput Remove
Remove the local output given by the output ID.
OutputId: A unique identifier for the local output.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
Example:
xCommand Audio LocalOutput Remove OutputId: 6
OK
*r AudioOutputGroupRemoveResult (status=OK):
** end
Codec C90 API Reference Guide TC7.0, JANUARY 2014.
D14641.15
About the API xConfiguration
xCommand Audio LocalOutput AddConnector
xCommand Audio LocalOutput RemoveConnector
92
xCommand xCommand
Attach an output connector to the local output given by the output ID. A connector is defined by its
type and ID.
OutputId: A unique identifier for the local output.
ConnectorType: Select the connector type.
ConnectorId: Select a connector.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
ConnectorType(r): <HDMI/Line>
ConnectorId(r): <1..8>
Example:
xCommand Audio LocalOutput AddConnector OutputId:5 ConnectorType: Line
ConnectorId:1
OK
*r AudioOutputGroupAddConnectorResult (status=OK):
** end
Detach an output connector from the local output given by the output ID. A connector is defined by
its type and ID.
OutputId: A unique identifier for the local output.
ConnectorType: Select the connector type.
ConnectorId: Select the connector.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
ConnectorType(r): <HDMI/Line>
ConnectorId(r): <1..8>
Example:
xCommand Audio LocalOutput RemoveConnector OutputId:5 ConnectorType: Line
ConnectorId:1
OK
*r AudioOutputGroupRemoveConnectorResult (status=OK):
** end
API Reference Guide
xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.