Table of Contents
Advertisement
Unpacking
1.
Place the box on a steady, at surface. Lift the machine out of the box and remove the outer packaging
and lift off the machine carrying case.
2.
Remove all other packing material and the plastic bag.
3.
Slide off the accessory tray and remove the styrofoam inside.
Note: Styrofoam left in the accessory tray while sewing may affect stitch quality. The styrofoam is for packing
purposes only and should be removed.
Note: Your
Extreme hot and cold temperatures can affect the sewn result.
Connecting the foot control cord
Among the accessories you will nd the foot control
cord. Connecting the foot control cord to the foot
control is only neccessary the very rst time you are
going to use the machine.
1.
Take out the foot control cord. Turn the foot
control over. Connect the cord to the socket
inside the open space on the underside of the
foot control as shown.
2.
Push rmly to make sure it is properly
connected.
3.
Pull the cord into the slot to the left of the socket
to ensure that the foot control will rest evenly
on the oor.
Connect the power cord
and foot control
Note: Before plugging in the foot control, check to ensure
that it is type "FR5" (see underside of foot control).
1.
Connect the foot control cord to the front socket
on the bottom right side of the machine (A).
2.
Connect the power cord to the rear socket on
the bottom right side of the machine (B). Plug
the cord into a wall socket.
3.
Press the ON/OFF switch to ON to turn on
power and light (C).
For the USA and Canada
This sewing machine has a polarized plug (one
blade wider than the other). To reduce the risk
of electric shock, this plug is intended to t in a
polarized outlet only one way. If the plug does
not t fully in the outlet, reverse the plug. If it
still does not t, contact a quali ed electrician to
install the proper outlet. Do not modify the plug
in any way.
2:2
is adjusted to provide the best stitch result at normal room temperature.
C
A
B
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Creative Performance and is the answer not in the manual?