26
en | Installing a Surface Mount
Numbe
r
3
4
5
6
7
8
Caution!
To prevent humidity problems, the camera must be installed in
!
dry conditions, and the cable leads should be sealed after they
are connected.
1.
2.
3.
4.
5.
6.
7.
2013.4 | |
Description
Camera base
O-ring
#8 x 32 screw
Safety strap (will hold item #7 dome cover for
easy installation)
Dome cover
M4 x 12 Torx screw
Determine a secure location that can support the weight of
the dome.
Use the template (refer to , page 25, item 1) to mark the
locations of the four screw holes and the cable conduit.
Pre-drill the four screw holes wide enough to accept the
plastic anchors.
Cut out the entire cable conduit hole.
Insert the four plastic anchors (item 2) inside the pre-
drilled holes.
Route the cables from the camera through the conduit in
the ceiling.
Remove the dome cover (item 6) from the camera base
(item 3).
AUTDOME 4000 Mini
PTZ Dome
Bosch Security Systems, Inc.