Video Loss Alarm - Honeywell FUSION III DVR User Manual

FUSION III DVR Digital Recording and Transmission System

5.4.4 VIDEO LOSS ALARM

The DVR supports a Video Loss Alarm function which allows an Alarm Event to occur
when a camera loses its signal. The lost signal can be due to Power failure to the
camera, the camera cable being cut or unplugged, or the camera being damaged in
some way.
In order to use Video Signal Loss detection, cameras must either be ENABLED or
DISABLED. This is because the DVR needs to know which cameras it should expect to
receive signals from. To ENABLE camera(s), open Frame Setup, and set the Frames
Per Second to anything above zero. By designating zero frames per second the
camera will not be used by the DVR.
1
2
3
5–10
When video loss occurs, an
Activate
internal speaker on the DVR
Audio Alarm
will sound an alarm.
(BEEP)
When video loss occurs, the
Video Loss
event is recorded in the DVR
Alarm Log
log.
Activates the last Relay
Activate
Output on the DVR when
Alarm Output
camera loses signal. (This is
#16 for a 16/32 ch DVR and
#8 for an 8ch DVR)
1
2
3