Table of Contents
Advertisement
NetDVR.book Page 45 Wednesday, May 12, 2004 4:06 PM
NetDVR | User's Guide | Playback
Installing and formatting the Hard Disk Drive
Important: Make sure power is disconnected from the NetDVR before working on the
unit.
Removing the HDD cradle:
Unlocking and removing the HDD cradle from
the Rack.
•
Find the correct position of the key, push in
and turn the key 45 degrees anticlockwise
to unlock. This also disconnects the HDD
power.
•
Lift handle and pull so the cradle slides out
of the rack.
•
Release the hook in the front left part of the
cover and slide the cover backwards to
remove.
Preparing the HDD:
•
Handle the HDD with care, and take
measures to avoid damage by electrostatic
discharge.
•
Configure the jumpers on the HDD to
install as master. The illustration shows the
setting for Maxtor disks.
Installing the HDD:
•
Insert the power and IDE connectors.
•
Insert the HDD in the cradle. First insert
the connector side (B), push down this side
and drag to the rear in the cradle, then
push in at the front (A).
•
Fix the HDD with the 4 supplied screws.
Bosch Security Systems | 2004-01
45
MASTER
J50
J48
J46
J44
J42
Advertisement
Table of Contents
