Connecting Netdvr To A Hub On Internet Or Lan; Connecting Netdvr Directly To A Pc; Location - Bosch NetDVR User Manual

NetDVR.book Page 12 Wednesday, May 12, 2004 4:06 PM
NetDVR | User's Guide | Installation

2.1.4 Connecting NetDVR to a Hub on Internet or LAN

• Connect the NetDVR to the network
hub using the white direct cable
(supplied).
Note:
A remote user cannot access the NetDVR until its
network settings have been assigned. It requires
an unoccupied IP address to be assigned.
Caution:
Do not use the default IP address. Within a
closed network, random IP addresses may be
assigned as long as each one is unique. For a
private network connected to the Internet, a
registered IP address is required (available from
your Internet service provider).
Note:
The network address of the local user and that of the NetDVR must be within the same network segment.

2.1.5 Connecting NetDVR directly to a PC

To configure the NetDVR locally, it
can be connected directly to a PC.
• Connect the NetDVR to the PC's
LAN port using the crossover
cable (cable with red connectors,
supplied). Ensure that the local PC
and NetDVR both have their
network address set within the
same network segment.

2.1.6 Location

• Place the NetDVR appropriately
for your purpose. Mount the NetDVR on a stable surface and avoid shock and vibration
especially during operation.
MAC address
The 12-digit MAC address of the NetDVR is on a label on the bottom. To correctly enter
this address using the ARP command, enter the "-" as separator to form a string of 6 two-
digit characters, i.e. 00408C100086 becomes 00-40-8C-10-00-86.
Bosch Security Systems | 2004-01
DC 12V
TO AC OUTLET
ETHERNET
DIRECT CABLE
(SUPPLIED)
ETHERNET
CROSS OVER CABLE
(SUPPLIED)
DC 12V
POWER SUPPLY
(SUPPLIED)
TO AC OUTLET
12
POWER SUPPLY
(SUPPLIED)