Battery Error Notification - Honeywell Dolphin 60s User Manual

2. Check the Battery Current. If the current is positive, then charging current is going into the battery. If
the current is negative, the battery is discharging current and your terminal is drawing more current
than the charging source.
Note: The charging current is always less than source current due to the terminal being in operation.
Charging a Severely Low or Completely Discharged Battery
Battery Charge Status
Severely Low
Completely Discharged
Use one of the following options to charge a severely low or completely discharged battery.
1. Insert the battery into the auxiliary battery well of the HomeBase. When the auxiliary battery LED on
the HomeBase turns green, the battery is fully charged.
2. Dock the terminal into the charging well of a peripheral (e.g., HomeBase). The terminal starts to boot
as soon as power is supplied by the base.
Note: To prevent the possible loss of unsaved data, do not remove the terminal from the base until the battery
has sufficiently charged. Touch the Start > Settings > System > Battery to view detailed information
on the status of the battery.
3. Charge the terminal from a wall power outlet using the USB Charge/Communication Cable and
power supply provided with your terminal. As the battery charges, the charge indicator LED will be
red. When the battery reaches a safe charge threshold, the terminal begins to boot. The length of
time before the battery reaches a safe charge threshold varies depending on the extent of the
battery discharge.
4. Charge the terminal from a USB host device (PC) using the USB Charge/Communication Cable.
Note: Inadequate source current may interfere with effective battery charging; see
Guidelines on page 3-11 for additional information.
As the battery charges, the charge indicator LED will be red. When the battery reaches a safe
charge threshold, the terminal begins to boot. The length of time before the battery reaches a safe
charge threshold varies depending on the extent of the initial battery discharge level and the current
supplied by the USB charging source.

Battery Error Notification

If your terminal displays the following indicators, replace the battery with a Honeywell Dolphin 60s
extended battery pack. For information on how to remove the battery from the terminal, see
the Main Battery on page
• An "Authentication Error" pop up window appears during startup.
• appears in the Title bar at the top of the touch screen.
• The General Notification LED illuminates red.
• A Notification appears on the Tile bar at the bottom of the touch screen.
3 - 12
Symptom
Pressing the Power button does not wake the terminal from Suspend mode. The general
notification LED may flash once when the Power button is pressed.
Pressing the Power button does not wake the device and the general notification LED
remains off.
2-12.
Important Charging
Replacing