Bosch Carephone 62 User Manual page 39

Carephone 62
CAUTION!
If the person receiving the emergency call hangs up without
terminating by pressing 0, the alarm will not be properly
processed. The Carephone 62 considers that the alarm is still
ongoing and will automatically dial the next destination number
in the programmed sequence. If there is only one destination
number programmed into the Carephone 62, it will call again
that same number.
9.
NOTICE!
Instead of the subscriber number, a personal message can be
recorded, e.g. "This is Mrs. Brown's emergency call unit...",
see Section 6.2.4 Programming steps, page 19.
Key functions on the destination phone
The following key functions on the destination phone can be
used for an emergency call with the Carephone 62.
Key Function
0 Terminate and acknowledge the call.
1 Extend the call by another 3 minutes.
2 Repeat the alarm message.
3 Speak with normal volume to the Carephone 62.
4 Listen to the Carephone 62.
5 Increase the volume and speak to the Carephone 62.
6 Reduce the volume and speak to the Carephone 62.
7 Duplex mode (two-way operation).
8 & 0 Cancel the repeated call function for the call by pressing 8 then 0.
9 Reject the call and terminate. The Carephone 62 dials the next
number on the list.
# Remote activation of the relay output, only when programming
step 72 is set to 6, see Section 6.2.4 Programming steps, page 19.
Bosch Security Systems
You can extend the call by a further 3 minutes by pressing
1 on the phone. The call can be extended as often as
required.
User Manual
Operation | en
F.01U.141.162 | V3 | 2012.11
39