Bosch Carephone 62 User Manual page 28

28 en | Programming
81-89 & 80 Assigning wireless transmitters
Registered wireless transmitters can be programmed to trigger different
alarm functions, e.g. a fire alarm. First, register the wireless transmitters
on the Carephone 62: refer to programming steps 90-99. To assign a
function to the wireless transmitter 91, select programming step 81.
– 0 = emergency call with a wireless transmitter (see step 50)
– 1 = emergency call with the Carephone 62 (see step 51)
– 2 = activity monitor reset with unit feedback (wireless daily button)
– 3 = sign in / sign out (see step 54)
– 4 = action button (see step 71)
– 5 = external input (when step 73 is set to 3)
– 6 = activity monitor reset without unit feedback (motion detection)
– 7 = connection to a destination number (with acknowledgement),
then enter the call sequence as a second parameter. First, press A to
delete the current value, then choose which call numbers 1 to 10 are
associated with this alarm function.
– 8 = output assigned in programming step 72
– 9 = fire alarm
– B = motion detection
– D = extended programming (access to these parameters with a
microSD memory card or remote programming)
91-99 & 90 Registering wireless transmitters
Up to 10 wireless transmitters or detectors can be registered with a code
number contained in the transmitter itself. These code numbers must be
stored in the Carephone 62. To register a wireless transmitter:
a. Select programming step 91.
b. The Carephone 62 announces: "Selection 91 is..."
c. Press the button of the corresponding wireless transmitter.
d. The Carephone 62 announces: "Selection 91 is..."
e. Press C to confirm. The wireless transmitter is now stored.
Restoring the factory settings deletes all registered wireless transmitters.
NOTICE!
If you try to register again a wireless transmitter with the same
code number, the Carephone 62 announces "failure".
F.01U.141.162 | V3 | 2012.11 User Manual
Carephone 62
Bosch Security Systems