Bosch Carephone 62 User Manual page 25

Carephone 62
61 Incoming call recognition
Incoming phone calls can be accepted and terminated by the Carephone
62's emergency call button or by using the wireless transmitter if it is
programmed for emergency call initiation. The ring tone on the Carephone
62 can be switched on or off and the volume can be adjusted.
– 0 = off (no incoming call can be answered and terminated by the
wireless transmitter or call button)
– 1 = with ring tone
– 2 = with loud ring tone
– 3 = with soft ring tone
– 4 = without ring tone (only the phone rings)
– Default value is 0.
62 Loudspeaker volume
This step is used to program the default volume as well as the maximum
and minimum settings. The default volume is the volume at which the
monitoring centre communicates via the Carephone 62.
Minimum setting is low volume. Maximum setting is high volume. Both can
be adjusted by the monitoring centre during a call.
Use settings 1 to 8 to program these three volumes. Default values are 4, 6
and 2.
63 Acoustical feedback for technical failures
The Carephone 62 can be set to announce technical failures through the
LED lamps and the loudspeaker, or through the LED lamps only.
– 0 = loudspeaker off
– 1 = loudspeaker on
– 2 = loudspeaker on from 7:00 to 21:00
Setting 2 is only available when the Carephone 62 is connected to a
monitoring centre that regularly gives real-time clock updates to the unit.
Check with your monitoring centre. Default value is 1.
Bosch Security Systems User Manual
Programming | en
F.01U.141.162 | V3 | 2012.11
25