Configuring Snmp; Configuring Upnp - HIKVISION DS-7600NI-SE/P Series User Manual

DS-7600 Series NVR User's Manual
3) If you have more than one device, you can register an account on
do some management.
4. Click the Apply button to save the settings.

Configuring SNMP

You can use SNMP protocol to get device status and parameters related information. To configure SNMP:
1. Select the SNMP tab to enter the SNMP settings interface, as shown in Figure 49.
2. Check the Enable SNMP checkbox.
3. Enter the IP address of SNMP host in the Trap Address textbox.
4. Enter the port of SNMP host in the Trap Port textbox
5. Click the Apply button to save the settings.
Note:
Before setting the SNMP, please download the SNMP software and manage to receive the device
information via SNMP port. By setting the Trap Address, the NVR is allowed to send the alarm event and
exception message to the surveillance center.

Configuring UPnP

Universal Plug and Play (UPnP) can permits the device seamlessly discover the presence of other
network devices on the network and establish functional network services for data sharing,
communications, etc. You can use the UPnP function to enable the fast connection of the device to
the WAN via a router without port mapping. To configure UPnP:
1. Select the UPnP tab to enter the UPnP settings interface, as shown in Figure 50.
2. Check the Enable UPnP checkbox.
3. Select the Mapped Type. There are two types:

Auto: Automatic mapping port 8000, 80, 554, 443.
Figure 49 SNMP Settings Menu
Figure 50 UPnP Settings Menu
www.hik-online.com to
58