Set Telemetry Path (6700/4400 Series Only); Check Port Number - IBM 6400 Series User Manual

Chapter 1
Printer Setup

Set Telemetry Path (6700/4400 Series Only)

The following procedure enables you to collect data using the Data Validation
application.
1. On the operator panel, press the PAUSE key to take the printer offline.
2. Press
the operator panel.
3. Press ↓ and
4. Press + until VALIDATOR displays.
5. Press ↓ until Telemetry Path displays.
6. Press + or – until Network Port displays.
7. Press
NOTE: Since only one port can be used at a time, DEACTIVATING HOST
8. Press ↓ and
9. Press PAUSE twice to put the printer back online.
For more information, refer to the Online Data Validator User's Manual .

Check Port Number

Make sure your printer port number has the same setting as the Ethernet
Interface.
To check the port number using the PMU, see page 20.
To check the port number on the printer, see Table 1 to determine the port
number menu location for your printer model. The default port number is
3001.
IMPORTANT
Do not set the Port Number to the same value as the Status Port Number
(the default is 3002) or the Mgmt Port Number (the default is 3007).
Printer Model
6700-M40 Series
6700 Series
4400 Series
6500 Series
6400 Series
14
. .
to place the printer in Menu mode. QUICK SETUP displays on
.
↵
at the same time to unlock the
↵
to activate it.
SERIAL displays.
If you later change the setting to Serial Port or Disabled,
REACTIVATING HOST SERIAL will display.
↵
at the same time to lock the
Table 1. Port Number Menu Location
INTERFACES Printer Mgmt PNE Port Number
PRINTER MGMT or Factory PNE Port Number
Factory PMU Port Number
PRINTER MGMT PRINTER MANAGER PORT NO.
SERVICE PRINTER MGMT
PRINTER MANAGER PORT NO.
↵
key.
↵
key.
Menu