Wep Encryption Tab - IBM 6400 Series User Manual

WEP Encryption Tab

You must click Read to obtain the printer's settings before you can modify
them.
NOTE: If the Ethernet Interface has a password assigned to the user guest,
Select which key you want to use for Wireless Equivalency Privacy (WEP)
encryption. Use the correct number and type of digits for your preferred
encryption strength (40 or 128 bit), then select ASCII or Hex.
Click Disable to disable WEP encryption for the selected printer.
Click Clear to clear all keys displayed on the WEP Encryption tab
simultaneously. (The keys stored in the Ethernet Interface are not affected.)
When you are finished, click Send to transmit the values to the printer. You
can transmit up to four keys at once, but only the selected key will become the
active key in the printer.
NOTE: If the Ethernet Interface has a password assigned to the user root,
NOTE: If the values are not in the selected format, or if the exact number of
If you are not going to modify settings on any other tabs, you must update the
printer for the settings to take effect. Click Update to update the printer.
IMPORTANT
Make sure the settings match those configured in the Access Point.
Figure 109. Wireless Properties: WEP Encryption Tab
then a Telnet guest password is required. See "Security Tab" on
page 58.
then a Telnet root password is required. See "Security Tab" on
page 58.
characters required is not entered, an error message will appear.
Correct the problem, then click Send again.
WEP Encryption Tab
131