Whirlpool ESTATE TES325E W Service Manual page 33

5. Remove the two screws from the bracket of
the hot surface indicator light.
6. Remove the screws from the element retain-
ing brackets, unhook them from the maintop,
and remove them.
7. Clean the bottom glass of the new maintop
and remove any debris.
Wiring With One
Hot Surface Indicator
Wiring With Four
Hot Surface Indicators
BRACKET SCREW
RETAINING
BRACKET
ELEMENT
BLACK
BROWN
ELEMENT
BLK
IF NECESSARY,
HOT SURFACE INDICATOR
UNHOOK THIS END
LIGHT BRACKET
TO REMOVE BRACKET
& SCREWS
BRACKET SCREW
RETAINING
BRACKET
ELEMENT
BLUE
BROWN
ELEMENT
BROWN
IF NECESSARY,
HOT SURFACE INDICATOR
UNHOOK THIS END
LIGHT BRACKET
TO REMOVE BRACKET
& SCREWS
Cooking Products Service Manual
Original July, 1996
© 1996 Whirlpool Corporation
8. Lift the elements off the old maintop and place
them on the new maintop at the same loca-
tions.
9. Install the new maintop and reassemble the
range. REASSEMBLY NOTE: When reinstall-
ing the maintop, make sure that it is centered
on the range, that the side brackets are en-
gaged, and that the rear side flanges are
inside the end caps.
GROUND SCREW
BRACKET SCREW
BLACK
BLUE (2)
BLACK
WHITE
YELLOW
BLACK
BLUE
(2) BLACK YELLOW
BLACK
(2)
BLACK
BLACK
ORANGE
ELEMENT
BROWN
WHITE
(2) BLACK
ORANGE
CERAN GLASS
MAINTOP
GROUND SCREW
BRACKET SCREW
YELLOW
BLUE (2)
BLACK
BLACK
YELLOW
BLACK
BLUE
YELLOW
(2) BLACK
ORANGE
(2)
BLACK
BLACK
ORANGE
ELEMENT
BROWN
BLACK
(2) BLACK
ORANGE
CERAN GLASS
MAINTOP
3-5
4321893
Page 3-5
RETAINING
BRACKET
ELEMENT
IF NECESSARY,
UNHOOK THIS END
TO REMOVE BRACKET
RETAINING
BRACKET
ELEMENT
IF NECESSARY,
UNHOOK THIS END
TO REMOVE BRACKET