Removing The Hot Surface Indicators - Whirlpool ESTATE TES325E W Service Manual

REMOVING THE HOT SURFACE INDICATORS

WARNING
Electrical Shock Hazard
Disconnect from electrical supply before servic-
ing unit.
Failure to do so could result in death or electrical
shock.
CAUTION: When you work on the electric range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
GROUND
WIRE
SCREW
BACK OF MAINTOP
SCREWS
SCREW
STRAIN
RELIEF
3-6
1. Pull the range away from the wall so that you
can access the back.
2. Turn off the electrical supply to the range.
3. Open the oven door and remove the screws
from under the front of the maintop, then close
the oven door.
4. Slide the maintop forward as far as possible
and remove the ground wire and main har-
ness strain relief from the rear of the maintop.
5. Lay a protective covering between the maintop
and the range to protect the finish, then turn
the maintop over and lay it on the covering so
that you can access the components.
NOTE: Proceed to the next page and follow the
steps for the hot surface indicator you are servic-
ing.
WHEN INSTALLING,
ENGAGE MAINTOP
IN SIDE BRACKETS
AT THE LOCATIONS