Leveling The Range - Whirlpool ESTATE TES325E W Service Manual

LEVELING THE RANGE

IMPORTANT: When moving the range, slide it
onto a piece of cardboard (use a section of the
shipping carton for this purpose), to prevent dam-
aging the floor covering.
1. If not already done, connect the range's power
supply cord to an appropriate AC supply, then
carefully slide the range into position until it is
approximately 2 " from the rear wall. Remove
the shipping base cardboard from under the
range. As you push the range into place,
make sure that the rear foot engages in the
anti-tip bracket. Make sure that the range is
secure in the bracket by pulling forward on
the top of the range.
For proper baking results, the range must be level.
The height of the range must also be adjusted to
the height of the counter. To do this, use the
following steps.
2. Install an oven rack in the lower track and
place a spirit level on the rack.
3. Use an adjustable wrench, and turn the leg
levelers in the direction necessary to level the
range from side-to-side and from front-to-
back. The range should rest flat on the floor.
REAR FOOT
4. Reinstall the storage drawer in the range.
1-10
FRONT FOOT