Whirlpool ESTATE TES325E W Service Manual page 35

REMOVING THE HOT SURFACE
INDICATOR (1)
1. Bend the bracket up just far enough to access
the hot surface indicator, then press the two
locking arms against the indicator body, and
unsnap it from the bracket.
2. Cut the white and black wires coming from the
old hot surface indicator, and splice the wires
to the same color wires of the new indicator
with twist-on connectors.
3. Snap the new hot surface indicator into the
bracket hole and bend the bracket back into
place.
4. Reinstall the maintop and reassemble the
range. REASSEMBLY NOTE: When reinstall-
ing the maintop, make sure that it is centered
on the range, that the side brackets are en-
gaged, and that the rear side flanges are
inside the end caps.
BEND
BRACKET UP TO
ACCESS INDICATOR
MAINTOP
BRACKET
WHITE
WIRE
UNSNAP LOCKING
ARMS FROM
BRACKET
TWIST-ON
CONNECTOR
HOT SURFACE
INDICATOR
WIRES
BLACK
WIRE
HOT SURFACE
INDICATOR
Cooking Products Service Manual
Original July, 1996
© 1996 Whirlpool Corporation
REMOVING THE HOT SURFACE
INDICATORS (4)
1. Bend the bracket up just enough to access the
hot surface indicator lights.
2. Press on the locking arms of the indicators
and unsnap the assembly from the bracket.
Do not disconnect the wires at this time.
3. Snap the new hot surface indicator assembly
into the bracket and bend the bracket back
into position.
4. Disconnect the brown, white, blue, orange,
and yellow wires, coming from the old hot
surface indicators, and connect the same
color wires coming from the new assembly to
the maintop terminal locations.
5. Reinstall the maintop and reassemble the
range. REASSEMBLY NOTE: When reinstall-
ing the maintop, make sure that it is centered
on the range, that the side brackets are en-
gaged, and that the rear side flanges are
inside the end caps.
UNSNAP LOCKING
ARMS FROM EACH
INDICATOR
BEND
BRACKET UP TO
ACCESS INDICATORS
ORANGE
YELLOW
HOT SURFACE
INDICATORS
3-7
4321893
Page 3-7
BROWN
WHITE
BLUE
BRACKET