G Loading Paper In The Bypass Tray; Loading Paper In The Bypass Tray - Oce im4511 Operation Manual

Loading paper in the bypass tray

The bypass tray can be used for plain paper and special paper including labels. Up to 100 sheets of standard paper
can be set. For paper types that can be used in the bypass tray, refer to page 2-3.
NOTE
If the paper type or size is changed, be sure to enter the paper type and size as in step 4.
1 Open the bypass tray.
Bypass tray extension
Set the bypass tray paper guides to the
2
width of the paper to be used.
Insert the paper all the way into the bypass
3
tray.
When setting 11"x 17",
8-1/2" x 14", 8-1/2" x 13,
A3 or B4 paper, be sure
to extend the bypass
tray extension.
If the bypass tray
extension is not pulled
all the way out the size of
the loaded paper will not
be correctly displayed.
Set the paper face
down. If there is a
clearance between the
paper and the paper
guides, the paper may
not be fed correctly.
Adjust the guides so that
they contact the edges
of the paper.
NOTES
G When using 5-1/2" x 8-1/2" paper, A5 paper or
postcards, be sure to load them with their shorter edge
into the feed slot as shown in the illustration.
G When loading plain paper other than Imagistics
standard paper, special media other than postcards,
Imagistics-recommended transparency film, or paper
to be printed on the back, the paper must be loaded
one sheet at a time. Loading more than one sheet at a
time will cause misfeeds.
G When adding paper, remove any paper remaining in
the tray, combine it with the paper to be added, and
reload as a single stack.
G Do not use paper that has already been printed on by
a plain paper fax machine or a laser printer. This may
cause printed images to become dirty.
G Do not use paper that has already been printed on by
a thermal transfer or inkjet printer. In particular, paper
that has been printed on by a thermal transfer printer
(such as a word processor that uses a cassette) may
cause missing characters and smudges.
G When printing on transparency film, be sure to remove
each sheet as it exits the machine. Allowing sheets to
stack in the output tray may cause curling.
G Please use Imagistics-recommended transparency
film. Place the film in the bypass tray so that it is
oriented vertically with the label side face up. If the
label side is placed face down, smudging may result.
Label facing up
G When loading multiple sheets of transparency film in the bypass
tray, be sure to fan the sheets several times before loading.
Set the type and size of the loaded paper.
4
When the paper system is changed from the inch
system to the AB system or vise versa or when the
paper type is changed, the paper type must be
designated. For setting the paper type and paper
size, see page 2-5.
5 Loading paper in the bypass tray is now
complete.
DUPLEX MODULE
3
3-3