Specifications; An Important Word About Power Levels; Important Safety Warning - LDG KT-100 Operation Manual

Automatic tuner for kenwood transceivers
Table of Contents

Advertisement

SPECIFICATIONS

0.1 to 125 watt power range (SSB and CW), 100W on 6M.
Latching relays for ultra-low power operation.
2000 memories for instantaneous band changing.
Controlled from Kenwood Tuner button on radio. Powered from Kenwood radio.
Works with any Kenwood radio that is AT-300 compatible.
Partial radio list: TS-50, TS-480
Tuning time: 0.1 to 6 seconds full tune average, 0.1 seconds memory tune.
1.8 to 54.0 MHz coverage. Built-in frequency sensor.
Tunes 4 to 800 ohm loads (16 to 150 on 6M), 16 to 3200 ohms with optional 4:1 Balun.
For Dipoles, Verticals, Vees, Beams or any Coax Fed Antenna.
Optional external Balun allows tuning of random length, long wire or ladder line fed
antennas.
Includes Kenwood interface cable.
Dimensions: 6.5L" x 6.5W" x 1.5H".
Weight: 2 pounds

AN IMPORTANT WORD ABOUT POWER LEVELS

The KT-100 is rated at 125 watts maximum power input at most. Many ham transmitters and
transceivers, and virtually all amplifiers, output well over 125 watts. Power levels that
significantly exceed specifications will definitely damage or destroy your KT-100. If your tuner
fails during overload, it could also damage your transmitter or transceiver. Be sure to observe the
specified power limitations.

Important Safety Warning

Never install antennas or transmission lines over or near power lines. You can be
seriously injured or killed if any part of the antenna, support or transmission line
touches a power line. Always follow this antenna safety rule: the distance to the
nearest power line should be at least twice the length of the longest antenna,
transmission line or support dimension.
2
Note: When using the KT-100 with TS-480 HX (200 watt radio), the TS-480HX will only transmit 100
watts. The TS-480HX is programmed by Kenwood to limit the power to 100 watts when an external tuner
is detected. LDG recommends the AT-200 Pro for use with the TS-480HX, so that the full 200 watts may
be realized.
2
, TS-570, TS-690, TS-850, TS-870, TS-2000.
PAGE 4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents