Ipod Direct Mode Controls - Numark iDJ2 Reference Manual

33. LOOP OUT - Sets the end point of the loop. The first time you press LOOP OUT while a song is playing, the
LOOP OUT button will blink and the song will begin playing in a seamless loop starting from the "loop in" point
and ending at the "loop out" point. To release or end the loop, press LOOP OUT a second time and play will
continue forward when the song passes the previously set loop out point. The LOOP IN button will then be
continuously lit, indicating that the loop is now in memory for re-looping purpose.
Please note: The LOOP OUT button can also be used to create a live cue point. Once you press LOOP OUT,
a cue point will be set at that location in the music. You can always return to this cue point by holding down
CUE and pressing the LOOP OUT button – the deck will pause and return to the LOOP OUT point. You can
resume playback from this point by pressing the PLAY button.
34. RELOOP - Repeats play "stutters" from the "Loop In" point. If a loop has been set, it plays and repeats a
previously set loop, until it is released by pressing LOOP OUT a second time.
LOOPING EXAMPLES

iPod DIRECT MODE CONTROLS

In iPod Direct Mode, some of the controls on Deck A become iPod controls,
allowing you to browse and play content from your iPod.
TAP – Functions as "Enter" command on your iPod.
LOOP IN – Functions as "<<" on your iPod.
LOOP OUT – Functions as ">>" on your iPod.
RELOOP – Functions as "Menu" on your iPod.
JOG WHEEL – Functions as your iPod's touchwheel controller.
PAUSE – Functions as "Pause" on your iPod.
PLAY – Functions as "Play" on your iPod.
Please note: iPod Direct Mode can only be used on Deck A. To
enable iPod Direct Mode, press the Mode button and change the
iPod Mode setting to Direct. See "iPod Direct Mode" for more
information on this mode.
Press LOOP IN to set the beginning of the loop, then press LOOP OUT
to set the end point of the loop. Once you press LOOP OUT, the iDJ²
will loop between these two points. If you press LOOP OUT again, the
iDJ² will exit the loop and continue playing normally.
The "Loop In" point can also be used as a way to "stutter"
play beginning from a certain point in a song. Just press
LOOP IN to set the "Stutter" point, then press RELOOP to
begin play from the "Stutter" point. Each time you press
RELOOP, the iDJ² will jump back to the "Stutter" point and
play from that point.
14
If you press LOOP IN but then decide you
want to set a different "Loop In" point, just
press LOOP IN again. Then press LOOP
OUT to start looping between the in and out
points.