Rear Panel Overview - Numark iDJ2 Reference Manual

REAR PANEL OVERVIEW

1. DC IN – Please connect the supplied power adapter (DC 12V 2A) to this power input and connect it o a
power source. Please only use the supplied power adapter – using an alternate power adapter may
result in damage to the iDJ². You may secure the adapter cable to the restraint directly below to
prevent from accidental unplugging.
2. POWER – Use this switch to turn the iDJ² on and off. To turn on, press the button momentarily. To
turn off, press and hold down the button until the unit has powered down completely.
3. MASTER BALANCED OUT – These line-level balanced XLR connections output the stereo mix and
should be connected to an amplifier or speaker system. Please use balanced XLR (TRS) to connect to
your speakers or amplifier.
4. MASTER OUT – This line-level stereo RCA connection outputs the stereo mix. Please use a stereo
RCA cable to connect to a stereo system or amplifier.
5. RECORD OUT – This is an additional line-level stereo RCA connection which outputs the stereo mix.
If you would like to record your mix as you are performing or output to additional speakers, please use
a stereo RCA cable to connect to your recording device or speaker system.
6. S-VIDEO – If using a video iPod, the iDJ² can output the video signal through this S-video port. Please
use a standard S-video cable to connect to a TV, monitor, or projection device. This will enable you to
display videos from your iPod.
Note: Video from your iPod can only be output when Deck A is in iPod Direct Mode. See "iPod
Direct Mode" for details.
7. INPUT 1 – Use a stereo RCA cable to connect a line or phono-level audio source to this input.
8. INPUT 2 – Use a stereo RCA cable to connect a line or phono-level audio source to this input.
9. LINE | PHONO – Each input features a Line | Phono switch. This switch should be set to either Line or
Phono, depending on the input signal. If using phono-level turntables, set this switch to Phono. If
using line-level sources, such as digital turntables and CD-players, set this switch to Line.
10. GROUND CONNECTORS – If you are using phono-level turntables, please make sure that you attach
the grounding wires of the turntables to these ground connectors. This will ensure that there is no
ground hum while you perform.
11. USB INPUTS – Please attach your mass storage media to these two available USB ports – a hub can
be used to expand to more USB inputs. You may also connect a USB keyboard to one of these ports
for quick navigation of the iDJ². (See "Keyboard Navigation and Shortcuts" section to learn about
keyboard shortcuts).
Note: The iDJ² supports the FAT and HFS+ file systems. Please make sure that the media you are
attempting to play is formatted in one of these file system formats.
12. KENSINGTON LOCK – Use this lock to attach and secure the iDJ² to a table or surface.
6