Related Manuals for Numark DM-950
Summary of Contents for Numark DM-950
- Page 1 DM-950 DJ Mixer Operating Instructions INSIDE THE BOX: (1) DM-950 DJ (1) DM-950 Mixer Power Adapter...
-
Page 2: Safety
Thank you for buying this Numark product package. Please read these operating instructions so you will know how to operate all of this equipment properly. After you have finished reading these instructions, keep them for future reference. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. -
Page 3: Table Of Contents
CAUTION! TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. IMPORTANT The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. -
Page 4: Mixer Controls
MIXER CONTROLS General Mixer Controls for DM-950 1. AC In and Power Switch This mixer is compatible only with the included power cable. Connect the AC plug into the jack on the rear of the mixer (A.) The mixer should be switched on after all devices are already connected to prevent damage to your equipment. A Red Power LED indicates that the unit has been switched on. - Page 5 MIXER CONTROLS PAGE 4...
- Page 6 MIXER CONTROLS continued Input and Power Section NOTE: It is recommended that the mixer be turned off before connecting or disconnecting anything to/from the mixer. A. Power Switch and AC Jack Use only the included AC Power Adapter when operating this mixer. See Control 1 for additional notes on powering the mixer.
-
Page 7: Setup & Installation
SETUP & INSTALLATION This mixer was designed to be placed between turntables and table top CD players. It is important that there is at least ¼" (7mm) between the mixer and the turntables or CD players to prevent damage to the equipment and to reduce unwanted system noise. -
Page 8: Specifications
SPECIFICATIONS Inputs: Line: 18K ohm input impedance 200mV rms sensitivity for 4V output Mic: 3K ohm input impedance unbalanced 2mV rms sensitivity for 4V output 20mV rms max input Phono: 47K ohm input impedance 3mV rms sensitivity @ 1KHz for 4V output Outputs: Master:... -
Page 9: Warranty Information
LIMITED PRODUCT WARRANTY 1. What is covered and for how long? NUMARK INDUSTRIES LCC ("NUMARK") warrants to the original purchaser that NUMARK'S mixers are free from defects in material and workmanship under normal use and service for the period commencing... -
Page 10: Return Information
Requests must be submitted in writing with merchandise returned. g) The defective Numark equipment should be sent, FREIGHT PREPAID with Return Authorization number clearly printed on the outer packaging and original sales receipt enclosed to: NUMARK INDUSTRIES Attention: Service Department 11 Helmsman Avenue... -
Page 11: Troubleshooting
Problem Mixer does not turn on. Disconnected Power Cord? The sound level is very low. The Turntable is not connected to a device with a PHONO preamp. The sound is on one side only. The RCA audio cord is disconnected. The RCA audio cord is damaged. - Page 12 INSIDE THE BOX: (1) DM-950 DJ (1) DM-950 Mixer Power Adapter DM950 Manual/ English Copyright Numark Industries, LLC 2002...