Power Trim And Tilt Switch On Remote Control; Power Trim And Tilt Switch On Bottom Engine Cowling - Yamaha LZ300 Owner's Manual

sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
ON
OFF START
EMU32051
Power trim and tilt switch on remote
control
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch " " (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position.
NOTE:
For instructions on using the power trim and
tilt switch, see pages 53 and 55.
" (on) position.
ON
OFF START
ZMU04566
" (up) trims the
Basic components
EMU26152
Power trim and tilt switch on bottom
engine cowling
The power trim and tilt switch is located on
the side of the bottom engine cowling. Press-
ing the switch "
motor up, and then tilts it up. Pressing the
switch " " (down) tilts the outboard motor
down and trims it down. When the switch is
released, the outboard motor will stop in its
current position.
EWM01030
WARNING
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
while the boat is moving could increase
the risk of falling overboard and could
distract the operator, increasing the risk
of collision with another boat or an obsta-
cle.
" (up) trims the outboard
21