Step 6: Connect Cables To Sound Blaster Audigy 2 Card - Creative Sound Blaster Audigy 2 Platinum User Manual

Step 6: Connect
cables to Sound
Blaster Audigy 2
card
• Use the AD_EXT cable with
the Audigy 2 Drive ONLY.
Do not attempt to use a
conventional IDE cable or
any other cable with the
Audigy 2 Drive as that may
cause electrical shorts and
permanent damage to the
Audigy 2 card and Audigy 2
Drive, which will void the
warranty for this product.
Your computer may
potentially be damaged
too.
• Align the red-colored wire
to Pin 1 of the connector
(see Figure 1-13).
You may also connect all the
cables to the Sound Blaster
Audigy 2 card first (as shown
in "Step 6: Connect cables to
Sound Blaster Audigy 2 card"
on page 1-20) before securing
the card and Joystick/MIDI
bracket in place.
1. Connect the Joystick/MIDI cable to the Joystick/MIDI connector on the Sound
Blaster Audigy 2 card as shown in Figure 1-13.
A
Figure 1-13: Connecting the cables to the Sound Blaster Audigy 2 card.
2. Connect the AD_EXT cable from the Audigy 2 Drive to the AD_EXT connector on
the Sound Blaster Audigy 2 card.
3. Connect the Internal SB1394/FireWire cable from the Audigy 2 Drive to the
Internal SB1394/FireWire port on the Sound Blaster Audigy 2 card.
3
B
C
1
2
E
A: Internal SB1394/
FireWire cable
B: Pin 1
C: AD_EXT cable
D: Red-colored wire
E: Joystick/MIDI
cable
Installing Hardware
D
1-20